V2000-c Rfid Access Control User Manual 'link'
The V2000-C is a 125KHz RFID standalone access control keypad designed for single-door security, supporting up to 1,000 users with card or PIN access. Programming involves entering a master code to add/delete users, configure door open times, and manage system settings. Official digital copies of the V2000-C User Manual are available at www.goldbridgesz.com
- Can manage users but may not change core system settings.
- Power off the V2000-c.
- Locate the two-pin reset jumper on the PCB.
- Short the jumper with a shunt or screwdriver.
- Power on the device while shorted. You will hear a continuous beep.
- Remove the jumper. The device resets to factory settings (Master code
123456, all users deleted).
- Compact, wall-mounted design that fits standard doorways.
- RFID-based: fast, contactless authentication with keyfobs or cards.
- Flexible user management for small organizations (hundreds to low thousands of users, depending on configuration).
- Basic logging capability to audit recent entries.
- Options for electric strikes, magnetic locks, and integration with alarm or door sensors.
- Simple wiring and straightforward configuration make it DIY-friendly for competent installers.
(Note: this is an instructional and practical guide meant to complement the official user manual. Always consult the manufacturer’s manual and local regulations before installation.) V2000-c Rfid Access Control User Manual
