Skip to content
  • There are no suggestions because the search field is empty.

Ts1162 Installation Manual

Tecom TS1162

The is a 3 LED Remote Arming Station (RAS) keypad designed for the Challenger security system. It is frequently used in environments requiring robust construction, such as dusty or wet locations, due to its IP67 rating . 1. Key Specifications

: Ensure all power is turned off to the Challenger control panel before beginning any wiring. Environment ts1162 installation manual

Section 5: Calibration and Testing Procedures

: If the TS1162 is the last device on the LAN run, set DIP switch 8 to the "ON" position for proper termination. aritech.com.au 4. Wiring and Connectivity Challenger LAN : Connect to the RS-485 LAN terminals (D+, D-, +12V, 0V). Inputs/Outputs Request to Exit (RTE) Tecom TS1162 The is a 3 LED Remote

  • Evaluation: Determine if all necessary steps for a successful installation are included. Are there any prerequisites or tools needed that are not mentioned?
  • Feedback: The manual covers the essential steps for installation but could provide more troubleshooting tips for common issues that might arise.
  • Socket Wrench.
  • Sockets (typically 10mm or 13mm—check specific manual).
  • Flat-head screwdriver or trim removal tool (for accessing factory covers).
  • Torque wrench (highly recommended for proper tightening).
  • Clean cloth/Isopropyl alcohol (for surface preparation).
  1. Choose a rack position allowing airflow at front and rear.
  2. Install cage nuts into rack rails where unit will mount.
  3. If using rails: install rails per rail kit instructions and slide chassis into rails until it latches.
  4. If using ears: align front ears with rack posts and secure with rack screws through the ears into cage nuts.
  5. Secure the unit with at least two front screws; for heavy loads, secure rear as well.

2.2 Panel Mount (Flush)

Perform outdoors on a clear day (fresh air ≈ 420 ppm). Evaluation : Determine if all necessary steps for