Times Now NavbharatTimes NowZoomET NowET Now SwadeshET Now AdvisorTimes DriveHealth and MeMarathiBengaliTeluguTamilMalayalam
लाइव टीवी

Sinotimer Mc101 Manual !full! • Free Forever

The Sinotimer MC101 Go to product viewer dialog for this item.

Part 2: Initial Setup – Clearing the Memory and Setting Time

  1. STOP/RST (Stop/Reset): Stops timing, resets display to set value, and de-energizes the relay.
  2. START (Start/Enter): Starts the timer or confirms a setting.
  3. SET (Set/Change): Enters programming mode or changes digits.

RTD (3-wire):

Connect the resistor element between Terminals 8 and 9 , with the third "extra" wire going to Terminal 10 . Control Output: sinotimer mc101 manual

1. Hardware Overview & Installation

is a 1/16 DIN (48x48mm) PID temperature controller featuring a four-digit LED display and 0.3% measurement accuracy. This guide outlines the essential steps for installation, wiring, and programming based on official technical documentation. The Sinotimer MC101 Go to product viewer dialog

It is recommended to run the auto-tune function upon first use to allow the device to "learn" the thermal lag of your specific setup. Safety & Maintenance Heat Dissipation: STOP/RST (Stop/Reset): Stops timing, resets display to set