Mks Laser Tool Setup V112exe Upd Download Free 🔥 Free Access
MKS Laser Tool Setup v1.1.2.exe
The is a configuration and firmware utility primarily used for Makerbase MKS DLC32 and MKS Robin series motherboards found in laser engravers. It allows users to flash firmware, configure Wi-Fi settings, and customize the machine's UI. Official Download Sources
- Scan with VirusTotal – Upload the file to VirusTotal (free). It should show 0/60 detections.
- Check the digital signature – Right-click the file → Properties → Digital Signatures. A legitimate MKS file will show "MKS Instruments, Inc.".
- File size – Genuine v112 setup is approximately 18-22 MB. Anything smaller (e.g., 300KB) is likely a dropper for malware.
- $X, $Y, $Z steps/mm: Adjust these if your engraved dimensions are off (e.g., a 100mm square comes out as 98mm).
- $30 (Max Laser Power): Default is 1000 for diode lasers. Do not exceed your laser module’s rating.
- Write to EEPROM: Always click this after changing any parameter.
| Problem | Solution | |---------|----------| | "Device not found" | Reinstall the CH340 or CP2102 USB driver (included in the tool’s driver folder). | | Crashes on Windows 10/11 | Run in compatibility mode: Right-click EXE → Properties → Compatibility → Windows 7. | | Chinese text in UI | V1.12 has an English/Chinese toggle in the top-right corner. Click the language button. | | Can’t send files | Convert your design to NC or G-code first. The tool does not accept SVG/PNG directly. | mks laser tool setup v112exe download free
: Adding position preview codes to G-code exported from software like GRBL. UI Customization MKS Laser Tool Setup v1