Id6100 Danieli Manual Hot May 2026

Go to product viewer dialog for this item.

The is an industrial infrared hot metal detector (HMD) and loop scanner produced by Danieli Automation . It is a critical sensor used in steel rolling mills to detect the presence and position of glowing metal bars at temperatures typically exceeding 700°C (1300°F). Key Specifications & Function

Digital Outputs:

NPN and PNP open collector outputs for material presence. id6100 danieli manual hot

1. Disengage the mechanical latch at the bottom of the ID6100.
2. Pull the module straight out (do not wiggle to avoid bending backplane pins).
3. Insert the new module. The bus will auto-reconfigure within 2 seconds.
4. Note: I/O cards with relay outputs should NOT be hot swapped under load to prevent contact welding.

specifically designed for harsh rolling mill environments. Its most useful feature is the built-in alignment laser Go to product viewer dialog for this item

• Diagnostic time drops to 15 minutes (reading the error buffer).
• Configuration time drops to 45 minutes (using the parameter cloning guide).
• Roll change alignment becomes precise (using the HGC offset procedure).

Warning:

The internet is filled with generic PDFs that claim to be the "ID6100 manual" but are actually translated HMI guides or old Level 1 diagnostics. Disengage the mechanical latch at the bottom of the ID6100

Power Supply:

Requires 24 VDC ± 20% with a consumption of roughly 7.2W.

Products › Automation › ID6000 Loop detectors ‹ Danieli