Hw 130 Motor Control Shield For Arduino Datasheet Better ^hot^

HW-130 Motor Shield (often based on the chipset) is a versatile, plug-and-play expansion board for Arduino Uno and Mega. It is designed to drive multiple inductive loads like DC motors, steppers, and servos simultaneously. 5.imimg.com Core Technical Specifications L293D H-Bridge drivers 8-bit shift register. Motor Voltage (VSS) : 4.5V to 16V (some variants support up to 36V). Logic Voltage (VCC) : 5V (powered by the Arduino). Output Current : 600mA continuous per channel (1.2A peak). Thermal Protection

HW-130 Motor Control Shield (often referred to as the L293D V1 Motor Shield) is a versatile expansion board for the Arduino Uno and Mega. It acts as a bridge, allowing the low-power signals from your Arduino to control high-power motors without damaging the microcontroller. Technical Specifications The core of this shield consists of two L293D dual-channel H-bridge drivers 74HC595 shift register to manage I/O pins efficiently. Motor Capacity 4 DC motors with individual 8-bit speed selection. 2 stepper motors (unipolar or bipolar). 2 "hobby" servos (5V) connected to dedicated high-resolution timers. Power Ratings : Supports motors between 4.5V and 25V : Provides 600mA per channel (1.2A peak) with thermal shutdown protection. Safety Features hw 130 motor control shield for arduino datasheet better

The shield breaks out two headers specifically for servos. These bypass the motor driver chips entirely. HW-130 Motor Shield (often based on the chipset)

  1. A printable one-page datasheet-style PDF with pinout, wiring diagram, and quick-start code.
  2. A wiring diagram image and annotated Arduino sketch matched to your exact pin mappings.
  3. A comparison table recommending alternate motor driver shields for higher-current needs.

Now go build something that moves.

  • Input voltage is too low. The L298N has a significant voltage drop (~2V to 3.5V). If you use a 6V battery, the motors only get ~3V. Increase battery voltage to 9V or 12V.

2 dedicated headers for 5V 'hobby' servos

connected to the Arduino’s high-resolution timers for jitter-free control. Power Management & Pin Usage A printable one-page datasheet-style PDF with pinout, wiring