Firstchip Fc1178bc Firmware Verified May 2026

FirstChip FC1178BC

The is a common USB controller found in low-cost or unbranded flash drives, often requiring specialized Mass Production Tools (MPTools) for firmware recovery or capacity correction. Because these controllers are frequently used in "fake" drives that misreport their storage size, verified firmware is typically used to reset the chip to its true capacity. Verified Tools and Firmware To repair or re-flash an FC1178BC controller

• VID/PID (Vendor ID/Product ID)
• NAND chip ID (e.g., 0xAD, 0xDE, 0x94, 0xEB, 0x64)
• Configuration page (the .DEF or .INI settings)

Configuration

: Press F1 or click "Setting" (password is usually blank or FCMP ). Set ScanLevel to 2 for a standard low-level format. firstchip fc1178bc firmware verified

The FirstChip (also known as iStar or Yeestorage) FC1178BC is a mass-production USB 2.0 controller commonly found in low-cost to mid-range USB flash drives manufactured after 2018. It is a single-channel controller that supports TLC (Triple-Level Cell) and QLC (Quad-Level Cell) NAND flash memory. FirstChip FC1178BC The is a common USB controller

• The tool must have a .fw or .bin file matching your Flash ID.
• If no matching firmware, the tool will say "Firmware not found" and you cannot proceed.

If you get a capacity error:

Some drives are counterfeit (e.g., labeled 64GB but only 16GB). The MPTool will "re-partition" to the real, functional capacity. VID/PID (Vendor ID/Product ID) NAND chip ID (e

1. Launch FC_MPTool.exe (run as administrator).
2. Click "Scan USB" – your device should appear.
3. Check "Verify Firmware" (critical).
4. Uncheck "Format after programming" (do that manually later).
5. Click "Start Download."
6. Wait for the progress bar to reach 100% – this takes 30–90 seconds.