Fanuc 7115 Alarm May 2026

FANUC 7115 alarm is a spindle-related fault, typically identified as the SP Switch Control Alarm

At its core, the 7115 alarm is a feedback loop failure. The CNC controller sends a command to the Fanuc servo drive, which in turn moves the motor. When the actual position reported by the encoder differs too significantly from the commanded position—often due to mechanical resistance or electrical glitches—the system triggers the 7115 code to prevent damage. Primary Causes fanuc 7115 alarm

  • Cross-check the questionable G-code against your machine’s manual. Just because it’s in a generic FANUC book doesn’t mean your builder turned it on.

    • 2. Alarm Meaning

    Configuration Mismatch

    : The Input/Output (I/O) sizes defined in the robot's EtherNet/IP setup do not match the sizes defined in the PLC (e.g., Allen-Bradley Logix controller). FANUC 7115 alarm is a spindle-related fault, typically

    1. Intermittent Electrical Noise or Grounding Issues
    Back to top