Daikin Brc1c51 61 Installation Manual Exclusive › (Plus)
Getting your Daikin BRC1C51/61 remote controller set up correctly is essential for managing your system efficiently. This wired controller is commonly used with Daikin's VRV and SkyAir systems.
Before diving into the wiring, you must identify which controller you are holding. daikin brc1c51 61 installation manual
3. Required Tools
- Master (Main): If used alone or as the primary controller.
- Slave (Secondary): If a second controller is added.
- Hold the back plate against the wall. Use a level.
- Mark the two screw holes (top and bottom).
- Drill holes, insert wall anchors.
- Feed the 2-core wire through the large hole in the center of the plate.
- Screw the plate to the wall.
- Strip 5mm of insulation off the wires and secure them under the P1 and P2 screws. Tighten firmly.
Once the power is back on, you may need to perform "Field Settings" to match the controller to your specific unit: Enter Service Mode: Getting your Daikin BRC1C51/61 remote controller set up
Route the control wire through the access hole or the top center outlet of the lower case before installing it onto the wall. Master (Main): If used alone or as the primary controller
| Part | Quantity | |------|-----------| | Remote controller (BRC1C51 or BRC1C61) | 1 | | Installation manual (original) | 1 | | Operation manual | 1 | | Screws for back plate | 2 | | Flat-head screws for wiring cover | 2 |
- Typical contents: controller head, mounting plate/backbox, installation screws, wiring terminal connector, user label/quick guide.
- Check for damage and confirm model number before installing.
